This picture was taken early on, before I realized that a 24" x 18" base
was overkill. I resized it to 18" x 18". The legs are 25.5" tall. That,
plus a layer of 2x4 for the top, gives a bandsaw table height of 41".
The vertical extension for the switch and speed controls is also too
tall here -- I later had to shorten it to be below the level of the
bandsaw table.
This picture was taken early on, before I realized that a 24" x 18" base was overkill. I resized it to 18" x 18". The legs are 25.5" tall. That, plus a layer of 2x4 for the top, gives a bandsaw table height of 41".
The vertical extension for the switch and speed controls is also too tall here -- I later had to shorten it to be below the level of the bandsaw table.